How To Use A Diamond Parting Tool

Due to this tangential angle all the cutting forces will be transferred down through the length of the tool tip.

How to use a diamond parting tool. Leaving only the top rake to be put on using the grinding jig that comes with the kit. On a practice spindle use a parting tool to cut two grooves near its center about 38 apart and 516 deep. Parting tools are mostly used for cutting through or forming shoulders and are essential in any workshop.

Then use the BP tool to round the sides of the center ring to form a bead. The 18 -3mm tool reduces the amount of waste vital if the timber is an expensive exotic one. At least on my Diamond parting tool.

Parting tools come in several different shapes. For lathes with a screw on chuck the parting tool must be used in a rear tool post with the lathe running in the normal direction. The ridge that runs the length of the sides of the tool makes the tool tippy as its positioned with this ridge directly on the toolrest.

Beading Parting Tool. The upright position of the tip during grinding produces a hollow grind on edges curved on either side of tip. The method of laying a parting tool on its side shown below is often taught but a difficulty arises when you use a diamond shaped tool.

Diamond Parting Tool - The special profile of this tool reduces the risk of binding in the cut. Unless done very carefully you gradually make the edge less acute. It also reduces the amount of heat build up caused by friction thereby lessening the chance of burning the bottom of the parted project.

As you do this practice looking at the horizon rather than directly at the cutting edge. No matter if you are looking for diamond parting tool to carry out with works like spinning smoothening cutting finishing or even shaping these superior diamond parting tool are irreplaceable for your business. Available exclusively at Woodcraft these tools represent great value and quality.