How To Turn Spindles On A Wood Lathe

When you put the turning blank on the lathe and the grain of the wood is parallel to the bed of the lathe then you are doing spindle turning.

How to turn spindles on a wood lathe. One way is to use the headstock and the rear spindle to suspend a piece of wood between the two and turn along the length of the piece of wood. Your drive spur makes the wood spin and the live center helps to hold it on the lathe. Adjust the height of the tool rest to match the tool you are using.

When the grain of the turning blank is at right angles to the lathe then you are doing faceplate or bowl turning. This made easy work of the blankslike sharping a large pencil. If you switch from a thick tool like a spindle roughing gouge to a thinner tool like a skew you will need to raise the tool rest.

Turn the workpiece to create a cylinder that. Nov 7 2018 - Explore Ray Browns board Spindle followed by 293 people on Pinterest. Prepare a spindle of appropriate length.

Set the fingers to just drop through barely touching the. You should cut above center for most lathe tools. Use the square-end tool to turn a ¼-inch groove in the back of the blank leaving a ⅜ outer rim of wood.

This is referred to as spindle turning and is the type of woodturning that is done to create long ornate table legs and other long wood turnings. Most spindles start out as square blanks. Most woodturning projects on the lathe are started by using a roughing gouge to create the basic shape whether a spindle bowl bottle stopper or nearly any other woodturning project.

With the spindle and machine set up complete youre ready to cut woodUsing a spindle gouge and holding the chisel approximately parallel to the floor gently probe the tip of the chisel into the spinning spindle. If the finished spindle will retain a square segment youll need to first turn a pommel the transition from square to round. See more ideas about wood turning wood turning projects turn ons.