How To Prime Exterior Wood For Painting

Another key step preparing trim for paint is priming.

How to prime exterior wood for painting. You might want to give it a light sand down too. Use a wide flat paintbrush to apply the paint to the wood. Sandpaper a few different grits Painting mask with ventilator Several paint brushes one for paint and one for primer at least.

Hold the spray gun approximately 1 foot from the surface. Before weathered wood can be painted it will require extensive prep work to ensure that the paint stays on for more than just a couple of years. Using a putty knife and vinyl exterior spackling compound fill any gouges.

However this will vary depending on the brand of. KILZ L220101 KLEAR Multi-Surface Stain Blocking. If the surface of your wood does not have bumps or any other imperfections apart from grains then you.

Priming the wood helps you deposit the paint nicely. Rusty nail stains Wash the rust off sand the nail heads down and caulk them with a good water-based all-acrylic caulk. Before you prime the wood must be clean and its advisable to sand it lightly to open the grain.

Spray a coat of paint onto the surface using even side-to-side sweeps and overlapping strokes. Scraping scrubbing and sanding. To start off priming use sandpaper to scrape off the previous paint or to even out the bumps on your surface.

To help the new paint adhere to the surface well Handyguy Brian advises to prime when painting over a glossy paint. There are some key points to note when preparing to paint exterior areas. Using the correct technique and quality paints will result in a painting job that is faster cheaper and easier to.