How To Prepare Outside Wood For Painting

To Summarize Prepping Exterior Trim For Paint Sanding filler caulking edges where trim meets another substrate allowing to dry.

How to prepare outside wood for painting. Again if possible paint on all sides. Another key step preparing trim for paint is priming. Scrape Loose Paint Caulk and Glazing Use a putty knife or multi-use paint scraper to remove flaking paint from the wood trim and loose glazing from the panes.

Before painting wipe or brush down any areas to remove any dust. To apply an even coat we recommend using an interior paint sprayer. Begin by scraping off old paints.

A light sanding by hand or with a palm sander for especially rough bare spots is highly recommended prior to priming. Fill any holes and cracks in your exterior surface with a high quality exterior filler. Avoid and drips or runs and make sure not to apply too much paint in one sitting.

Keep a wet edge by overlapping as you paint. Once you go over the boards with a roller grab a paint brush and get in the nooks and crannies and paint in between the boards to spread the paint all over. Instructions to Prepare Wood Panels 1 Clean off any dust or debris from all exposed areas of the panel including the cradled sides and panel back first using a vacuum or air pressure if very dusty then wiping clean with a microfiber cloth or other lint free cloth slightly dampened with water.

This type of primer will fill the wood pores and cavities in the wood. Go ahead and use sandpaper to smoothen any sharp edges. Use a painting tray to remove excess paint from your roller.

Flat putty knives or pull scrapers work well for this. For weatherboard use Selleys No More Gaps Exterior Weatherboard or Selleys Plasti-Bond Heavy Duty where movement is likely to occur. This will seal the bare wood and create an air- and moisture-tight barrier between the house and your new paint job.