How To Do Metal Framing Studs

In order to make the cuts we recommend you to use straight-cut thin snips.

How to do metal framing studs. Use the one that works best for you. Wire the skin nail plate over the perceived. Lay out the position of the track strike chalk lines and drill a hole through the metal and into the concrete the full length of the screw.

Cuts both sides with snips and score a line on the back. How to Hang Drywall on Metal Studs. Space the sheet metal screws about 6 to 8 inches apart.

Framing with metal studs After you have installed the metal track you have to install the first layer of studs. The same thing applies to T intersections as well. The proper way to handle an inside corner when you use metal stud framing is sliding that first sheet into the inside corner and fastening the last stud adjacent to the drywall.

Just like wood framing metal studs should be spaced 16 or 24 inches apart. Place a mark of metalworking glue through the metal plate posts on one side of the box press a plate panel on the front side and then add it with screws. Use a metal cutter to cut spaces in the cabinet board.

There are two primary cutting tools for steel studs. The red-handled snips cut left the green cut right and the yellow cut straight. Make sure you leave it loose until the drywall goes up.

Use a hammer drill fitted with a carbide tipped masonry bit. Actually if you want to create curves or archways with drywall boards you have to bend the metal tracks and then fit the steel studs in their channels. This means you use fewer studs and get a stable joint.