How To Carve A Soap

Once aligned the user can load the soap onto the build plate.

How to carve a soap. Soap Craft. Remove the brand name from the soap bar if it has one engraved on it. When the soap is fully dry draw an outline of the shape or design you wish to carve into the soap with the marker.

Take a fine tip marker and trace the letter. Let the soaps rest there for at least 6 weeks. Put the paper on the soap you may want to have shapes for the width and length separately as this soap carving is three dimensional then pin it to the soap with toothpicks and then gently have your kids give the soap the shape that they are striving for.

In a sense youre digging your design out of the bar of soap. Heres how to carve a shape that will turn out looking decently turtle-esque. Do this by using a sponge and water to rub it off.

A good way to approach this is to imagine you are excavating some delicate artifact. This length of time is necessary to allow the soaps ingredients to combine chemically creating a harder bar of bath soap. This will let you know where to stop when you begin to dig out the excess soap.

Use your knife to cut out the shape you have drawn on the soap. Now take your screwdriver and gently and carefully scrap out the soap on the inside of the circle. Once the soap mixture has been prepared and poured into the soap molds place the molds in a cool dark room.

Start using your knife to remove material from the bar of soap using your etchings as guidelines. Gently scrape off any brandingwording thats imprinted on the top of the bar of soap. Make rough cuts into the soap until youve cut down to the.