Diy Wood Lathe Chisel Sharpening Jig

DONE - DIY wood version of Wolverine jig for sharpening lathe gouge tools on bench grinder Wood turning Woodworking projects that sell Wood turning projects.

Diy wood lathe chisel sharpening jig. This is a very good alternative to it that sav. This is my sharpening system for my Lathe chisels. It will allow you to sharpen almost every kind of woodturning chisels on your lathe.

15-minute epoxy to secure the stoppers and markers. Mar 24 2017 - Explore Gioia Blixs board lathe tool sharpening jig on Pinterest. Another way is to pull the chisel in farther on the jig but I prefer the block method.

Moreover it comes with an easy setup. Here is what I came up with. I also drill another piece of plywood to secure the jig on the lathe.

Laminated OSB and scrap plywood for the base for everything. A 400100 grit diamond sharpening stone. The chisel has a little too much room to move around in so I think I need to build another one but for now it will work just fine.

It is based off of the One Way Wolverine Sharpening System. I took care of the primary bevel on the coarse side of the stone then made a secondary bevel on the fine side by lifting the back of the jig slightly with a block of wood. Same as any craft woodturning demands a strong foundation in the basics knowing the wood properties tools techniques and most especially design techniques or considerations.

Detailed plans for a homemade lathe chisel sharpening jig that can be attached to the lathe on this website. Lathe Techniques - Your Wood Turning Project Done Right - Mollerstead. I built a new chisel sharpening jig to make it easier to sharpen chisels hand plane blades and marking knives.